Removing The Lcd Module (Hp Authorized Service Providers Only); Table 2-7. Display Component Compatibility - HP OmniBook 3100 Service Manual

Removing the LCD Module
(HP Authorized Service Providers Only)
Note
The exact details for removing the LCD module depend on the type of module. Some details may
differ from those described below.
See the table below for information about matching components for different types of LCD
modules.
To identify the type of 12-inch LCD module, check the following:
• The Sanyo 12" DSTN module has two cutout holes in the frame on the left side of the glass,
and the main connector is below the centerline on the back of the module.
• The Samsung 12" TFT module has no cutout holes in the frame, and the main connector is
above the centerline on the back of the module.
OmniBook 2100
12" DSTN (Sanyo)
Bezel, display
Bracket, display
Bumper, display
Cable, inverter
F1580-60930
Cable, LCD flex
Case, display
Foam, EPE
Hinge, display
LCD module F1580-69003
PCA, inverter
PCA, LVDS
Required Equipment
• Small Phillips screwdriver, preferably magnetized.
• Pointed knife or probe.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Remove the floppy drive or other plug-in module (see page 2-4).
3. Open the display fully.
4. Slide off the two plastic hinge covers about 5 mm, then lift them off. Use your finger or a small
tool to push outward next to the hinge.
5. Pry out and pop up the right end of the icon window cover at the plug-in module slot, then pop off
the cover.
HP OmniBook 2100/3000/3100

Table 2-7. Display Component Compatibility

OmniBook 2100
12" TFT (Samsung)
F1580-60911
F1580-60916
F1580-60909
F1580-60951
F1580-60929
F1580-60907
(none)
F1580-60910
F1580-69002
F1580-60905
(none)
OmniBook 3100 OmniBook 3000
13" TFT (NEC) 13" TFT (NEC)
F1391-60927
F1391-60962
F1391-60924
F1580-60952
F1391-60961
F1391-60910
F1391-60926
F1391-60925
F1391-69007
F1580-60904
F1391-60904
Removal and Replacement
F1391-60959
F1391-60908
2-11