Figure 2-15. Removing The Heat Sink Assembly - HP OmniBook 3000 Service Manual

• Display assembly (see page 2-8).
• Keyboard (see page 2-11).
3. Remove the heat sink assembly by doing the following:
• Remove the three recessed screws from the heat sink assembly.
Note: Do not remove the two middle screws from the heat sink assembly. They hold a
permanent part of the assembly.
• Using your fingers or a small flat-blade screwdriver, press the heat sink assembly toward the
back of the computer until the three tabs along the front edge are free from the case.
• Disengage the front edge, then lift the right end of the assembly and unplug the fan cable from
the motherboard.
Heat Sink Assembly
F1391-60921
(includes fan/cable)
Do not remove
these two screws.
Fan cable
connector
CPU Thermal Kit (gasket and spacer)
F1391-60917
2-18 Removal and Replacement

Figure 2-15. Removing the Heat Sink Assembly

Screw, M2×5mm
F1391-60954 (3)
Note: Smaller diameter
Speaker/TouchPad
cable
HP OmniBook 3000