Call Forward No Answer - Nortel M7310 Quick Programming Manual

Call Forward No Answer

You can programme an extension to forward a call to a pre-determined extension if the
call is not answered within a set number of rings. The default setting is 4, but options 2,
3, 4, 6 and 10 rings are available.
If a designated extension is set on Do Not Disturb or Do Not Disturb On Busy, the
incoming call continues to ring at the original extension and the caller continues to hear
ringback. To lessen the chance of this happening, you can designate a second back-up
extension.
Calls coming in on an outside line are automatically transferred to the Prime extension
for that line.
ACTION
1. Begin the session by following the instructions under "To begin
a programming session" on page 9 using the System
Administrator Plus password.
2. Press ≠.
3. Enter the number of the extension you wish to programme (234
represents the number of the extension you have chosen to
programme.)
4. Press ≠.
5. Press '
6. Press ≠.
7. Press ≠.
8. Press .
CHANGE
9. Use the keypad to enter the extension to which you want the calls
sent. (Extension 221 is used in this example.)
When you have entered all the numbers, the display shows:
10. Press ® to exit the session.
After a few seconds, the date and time reappear on the
display.
26
VISUAL DISPLAY
Terminals&Extns
Show extn#:__
234:234
COPY FIND
Line access
COPY
Capabilities
COPY
Fwd no answer
Fwd to:None
CHANGE
Fwd to:__
CANCL
Fwd to:2__
CANCL BKSP
Fwd to:221
CLR CHANGE
End of session
1 Jan 1:00 am