Line Access; Line Assignment - Nortel M7310 Quick Programming Manual

S E C T I O N I V

Line Access

This section shows you both how to assign lines to individual extensions, and how to
programme the number of appearances of DIA lines at each extension.

LINE ASSIGNMENT

With this setting, you assign physical lines and Direct Inward Access (DIA) lines to each extension.
• DIA lines are assigned and removed in the same manner as other lines.
• In general, exchange lines are not assigned to extensions unless the extension is used for monitoring
incoming calls or making outgoing calls.
• You cannot assign a private line to another extension.
• Each assigned line must appear at an extension at a key with an indicator. If you set a line to Ring
only, incoming calls appear on the intercom key
EXCEPTION: Central Answering Position module is only available on the M7324N. The M7100N has
no line keys and is assigned any number of lines, but you must be sure that all lines assigned to the
M7100N are set to ring. Otherwise, incoming calls are not heard.
ACTION
1. Begin the session by following the instructions under "To begin
a programming session" on page 9 using the System
Administrator Plus password.
2. Press ≠.
3. Enter the number of the extension that you want to programme.
We used extension 221 for this example.
4. Press ≠.
5. Press ≠ twice.
6. Enter the line number. Line number 001 is used as an example.
7. Press to see the setting.
SCAN
8. Press to change the setting for each line to: Ring only,
CHANGE
Appr&Ring, Appr. Only or Unassigned.
9. Press ® to exit the session.
10. After a few seconds, the date and time reappear on the display.
VISUAL DISPLAY
Terminals&Extns
Show Extn#:
LIST
Show Extn#:22_
BKSP LIST
221:221
COPY FIND
Line access:
COPY
Show line ...
SCAN LIST
Show line:001
SCAN BKSP LIST
L001:Ring Only
SCAN FIND CHANGE
Appr&Ring
SCAN FIND CHANGE
End of session
15 Jul 1:30 pm
15