Display Ipv6 Neighbors - 3Com Switch 4500 Family Manual

Table 1-4 Description on the fields of the display ipv6 interface brief command
Field
*down: administratively
down
(s) : spoofing
Interface
Physical
Protocol
IPv6 Address

display ipv6 neighbors

Syntax
display ipv6 neighbors { ipv6-address | all | dynamic | static | interface interface-type
interface-number | vlan vlan-id } [ | { begin | exclude | include } regular-expression ]
View
Any view
Parameters
ipv6-address: IPv6 address whose neighbor information is to be displayed.
all: Displays information of all neighbors, including neighbors acquired dynamically and configured
statically.
dynamic: Displays information of all neighbors acquired dynamically.
static: Displays information of all neighbors configured statically.
interface interface-type interface-number: Displays information of the neighbors of a specified
interface.
vlan vlan-id: Displays information of the neighbors of a specified VLAN, in the range of 1 to 4094.
|: Uses a regular expression to match neighbor entries.
regular-expression: A case-sensitive string for matching.
begin: Displays the first matching neighbor entry and all the neighbor entries following it.
exclude: Displays the neighbor entries not matching the specified regular expression.
The interface is down, that is, the interface is disabled by using the
shutdown command.
Spoofing attribute of the interface, that is, the link protocol state of the
interface is up, but the link does not exist, or the link is established on
demand, instead of being permanent.
Name of the interface
Interface link state:
*down: Indicates the VLAN interface is administratively down; that
is, the interface is shut down using the shutdown command.
down: Indicates the VLAN interface is administratively up but its
physical state is down; that is, no port in the VLAN is up, which
may be caused by a link failure.
up: Indicates the administrative and physical states of the VLAN
interface are both up.
Link protocol state of an interface
down: Indicates the link layer protocol state of the VLAN interface
is down, generally because no IP address is configured.
up: Indicates the link layer protocol state of the VLAN interface is
up.
IPv6 address of the interface (If no address is configured for the
interface, "Unassigned" will be displayed.)
1-5
Description