3Com Switch 4500 Family Manual page 156

individual port takes the form of interface-type interface-number and a port range takes the form of
interface-type interface-number1 to interface-type interface-number2, with interface-number2 taking a
value greater than interface-number1. The total number of individual ports and port ranges defined in
the list must not exceed 10.
Description
Use the display port-security command to display port security configurations.
If no interface is specified, the command displays the port security configurations of all Ethernet ports.
The output of the command includes the global configurations (such as whether port security is enabled
on the switch and whether the sending of specified Trap messages is enabled) and port configurations
(such as the security mode and the port security features).
By checking the output of this command, you can verify the current configuration.
Examples
# Display the global port security configurations and those of all ports.
<Sysname> display port-security
Equipment port-security is enabled
AddressLearn trap is Enabled
Intrusion trap is Enabled
Dot1x logon trap is Enabled
Dot1x logoff trap is Enabled
Dot1x logfailure trap is Enabled
RALM logon trap is Enabled
RALM logoff trap is Enabled
RALM logfailure trap is Enabled
Disableport Timeout: 20 s
OUI value:
Index is 5,
Ethernet1/0/1 is link-up
Port mode is AutoLearn
NeedtoKnow mode is needtoknowonly
Intrusion mode is BlockMacaddress
Max mac-address num is 4
Stored mac-address num is 0
Authorization is ignore
(The rest of the information is omitted.)
# Display the port security configurations of ports Ethernet 1/0/1 to Ethernet 1/0/3.
<Sysname> display port-security interface Ethernet 1/0/1 to Ethernet 1/0/3
Ethernet1/0/1 is link-up
Port mode is AutoLearn
NeedtoKnow mode is needtoknowonly
Intrusion mode is BlockMacaddress
Max mac-address num is 4
Stored mac-address num is 0
Authorization is ignore
Ethernet1/0/2 is link-down
OUI value is 000100
1-3