Table of Contents
Advertisement
8
Adjusting the Flame Height
This fireplace has an adjustable flame to tailor the look and
heat output to your specific needs. It is adjusted by turning the
flame adjust knob.
Adjusting the Blower Speed (Optional)
The optional blower helps transfer heat from the heater
into the room. It will not turn on until the heater is up to
temperature (approximately 10 minutes after starting).
See the illustration to the right for instructions on adjusting
the blower speed.
Continuous Pilot / GreenSmart™ Pilot Switch
This fireplace may run with the pilot continuously running or in GreenSmart (intermittent) mode. For most
homeowners, the GreenSmart mode is preferred (this saves fuel, doesn't give off un-needed heat).
However, in some situations the homeowner may prefer to switch the fireplace to continuous pilot. The
most typical reasons for switching to continuous pilot are:
Very Cold Conditions – in very cold conditions you may
notice that the burner does not light quickly, and the flames
lift off the burner. If this is situation, we recommend you
switch to continuous pilot. This will create a slight draft in the
vent, allowing for the burner to light quickly and draft
correctly.
Excessive Condensation on Glass after Startup – certain
installations may encounter excessive fogging on the window
after startup (not just the first time the fireplace was started).
This is an aesthetic condition that may be remedied by
switching the fireplace to continuous pilot.
Cold Glass or Fireplace Front – in very cold conditions you
may notice that the fireplace front and glass become very
cold. To remedy this, switch the fireplace to continuous pilot.
Frequent On / Off Operation – if you are frequently turning the
fireplace on and off, you may wish to leave it in continuous pilot.
This allows the burner to turn on more quickly, without pilot ignition
delay.
© Travis Industries
Operation
4/22/21 - 1514
PB 24 CF GSB2 Operation
Advertisement
Table of Contents
