MAINTENANCE WORK ON CHASSIS AND ENGINE
x
Removing the oil filter
8.117
Warning
Danger of scalding Engine oil gets very hot when the motocycle is driven.
–
Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
x
Mounting oil filter
8.118
–
Loosen the plug
–
Remove plug
–
Completely drain the remaining engine oil.
–
Thoroughly clean parts and sealing area.
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Fit and tighten plug
Rules
Plug, oil screen
400261-11
–
Place a suitable container under the engine.
–
Remove screws
400262-10
–
Pull the oil filter insert
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean parts and sealing area.
400263-10
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Lay the motorcycle on its side and fill the oil filter housing to about 1/3 full with
engine oil.
–
Fill the oil filter with engine oil and place it in the oil filter container.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten screws.
Rules
Screw, oil filter cover
400264-10
–
Stand the motorcycle up.
with a few light hammer blows.
1
with oil screen
and O-rings.
1
2
with oil screen
and O-rings.
1
2
M32x1,5
. Take off the oil filter cover with the O-ring.
1
out of the oil filter casing.
2
M6
65
30 Nm (22.13 lbf ft)
.
1
10 Nm (7.38 lbf ft)