MAINTENANCE WORK ON CHASSIS AND ENGINE
Greasing the steering head bearing
8.32
–
Remove the lower triple clamp. (
–
Install the lower triple clamp. (
Dismounting the front fender
8.33
Installing the front fender
8.34
Dismount the start number plate
8.35
–
Mount and tighten screw
Rules
Screw, top steer-
ing stem
–
Check the cable harness, cable, brake and clutch line for free movement and free
laying
–
Check play of steering head bearing. (
500103-10
x
30)
30)
–
Remove screws
–
Make sure that the distance bushing remains in place.
500092-10
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Make sure that the distance bushes are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Rules
Remaining screws, chas-
sis
Info
Take care with the contact between the holding lugs and the start number
500092-10
plate.
–
Remove screw
–
Remove screw
500123-10
.
6
M8
17 Nm
(12.54 lbf ft)
27)
. Remove the front fender
1
M6
and take off clamp.
1
. Remove the start number plate.
2
Loctite
®
243™ (
84)
.
1
10 Nm (7.38 lbf ft)
31