Montigo 30FID Installation & Maintenance Manual page 53

12). Install both new Blowers. Secure the Wire Harness with the Zip
Straps shown in the 2 pictures below.
Figure 44 Sec.10
13). At this point, if you want to test the Blower operation, do so
with the Gas Supply turned off or disconnected. To test the Blower
operation, you will need to re-connect the electrical supply temporarily.
Disconnect the Electrical Supply after testing the Blowers.
Figure 45 Sec.10
14). Re-install the Outer Shell Rear panel.
15). You will need to replace the Flue Collar Plate Gasket prior to
re-installation into the cavity.
XG0514-092314
Maintenance
16). Replace the Flue Connector Plate Gasket.
Figure 46 Sec.10
17). Re-install the unit into the Cavity. See the section on Vent
Connections.
18). Re-install the Face Plate Panels. See the section on Setup.
19). Re-connect the Electrical Supply.
I-Series Indoor Gas Fireplace
Page 53