Montigo 30FID Installation & Maintenance Manual page 29

4) Temporarily, place the Electrical Cord through the hole in the
bottom right corner of the Rear Faceplate
Figure 28 Sec.7
5). Attach the Rear Faceplate to the Firebox using the screws
provided (13 locations)
Figure 29 Sec.7
6). Remove the twist tie and Zip Strap that is on the On / Off
Switch wire harness.
Figure 30 Sec.7
XG0513-092314
Installation
7). Slip the Split Plastic Grommet, found in the plastic bag attached
to the master override switch, around the Power Cable and then
press it into the provision on the right lower side of the Rear
Faceplate to secure the Power Cord.
Figure 31 Sec.7
8). Thread the On/Off Wire Harness through the gap between the
Control Board Mounting Bracket and the Rear Faceplate Panel.
Figure 32 Sec.7
9) Connect the Plug to the appropriate terminal on the Control Panel.
Figure 33 Sec.7
I-Series Indoor Gas Fireplace
Page 29