Montigo 30FID Installation & Maintenance Manual page 27

10). Place the Zip Strap through the hole in the Plastic Stick on
Retainer on the back of the Rear Faceplate. Zip the wires together
in one tidy package as shown.
Figure 18 Sec.7
11). Place the master override switch in the OFF position. Until
the remote is synced to the control board, this switch acts as a
master. If you apply gas and power to the unit while this switch is
in the ON position, it will initiate lighting.
Figure 19 Sec.7
XG0513-092314
Installation
12). At this stage it is easiest to install the batteries. See section
on battery installation and replacement.
13). The Front trim is now installed. It has two fasteners at the
bottom which must be engaged in the bottom right and left of the
Front Faceplate. Magnets hold it at the top right and left.
Figure 20 Sec.7
14) Screws to secure the Front Faceplate at the bottom left and
right.
Figure 21 Sec.7
15). Trim installation completed.
Figure 22 Sec.7
I-Series Indoor Gas Fireplace
Page 27