Montigo 30FID Installation & Maintenance Manual page 49

I-Series Indoor Gas Fireplace
Maintenance
3). When installing the burner into the fireplace, angle the burner
at the rear to insert the mixing tube into the rear burner support.
** Be careful not to knock or damage the pilot assembly
during this installation. **
Figure 28 Sec.10
4). Once this has happened, the 2 screws can be installed at the
front of the burner assembly to fasten the burner assembly into
the firebox. The screws will not line up with the holes if the mixing
tube is not inserted properly.
Figure 29 Sec.10
5). To ensure the burner assembly is installed correctly, try to lift
up the burner assembly at the rear. If the mixing tube is properly
inserted, the burner assembly will not move.
Page 49
XG0514-092314