Montigo 30FID Installation & Maintenance Manual page 30

I-Series Indoor Gas Fireplace
10). Place the Zip Strap through the hole in the Plastic Stick on
Retainer on the back of the Rear Faceplate. Zip the wires together
in one tidy package as shown.
Figure 34 Sec.7
11). Place the master override switch in the OFF position. Until
the remote is synced to the control board, this switch acts as a
master. If you apply gas and power to the unit while this switch is
in the ON position, it will initiate lighting.
Figure 35 Sec.7
Page 30
Installation
12). At this stage it is easiest to install the batteries. See section
on battery installation and replacement.
13). The Front trim is now installed. It has two fasteners at the
bottom which must be engaged in the bottom right and left of the
Front Faceplate. Magnets hold it at the top right and left.
Figure 36 Sec.7
14) Screws to secure the Front Faceplate at the bottom left and
right.
Figure 37 Sec.7
15). Trim installation completed.
Figure 38 Sec.7
XG0513-092314