Table of Contents
Advertisement
REMOTE VEHICLE STARTER
Quick View Programming
Menu 1 - Press
1 Ignition Lock
2 Horn Honk
3 Lock&Unlock Options
4 Unlock/Disarm
Menu 2 -Press
1 Secure Service Mode
2 Park Light Output
3 Horn Timing
4 Button #4 ( Button)
5 Reservation Mode
Menu 3 -Press
1 Lock/ Unlock Type
2 Gas/ Diesel
3 Rearm Output
4 Run Time
5 Crank Time
6 Starter Disable/GWR
7 Safety Start Mode
Menu 4 -Press
1 Low Idle Learn
2 Adjust For Over Crank
3 Adjust For under Crank
**Bold type indicates settings that are Factory Default.
System Reset
The system reset will clear any changes made to the Program Menu's as well
as the Tach setting. When the system reset is complete the system must be
Tach learned before the remote starter will operate.
1) Turn the ignition key from "Off" to "On" 3 times, ON-OFF-ON-OFF-ON within
three seconds. (Leave the key in the ON position)
2) Press and release the Program Button located on the antenna. The park
lights will turn on and the horn (optional) will honk one time.
3) Then press and hold the Program Button until the park lights flash and the
horn (optional) will honk 3 times slowly to confirm system reset.
System is now reset to factory defaults.
NOTE: System Reset does not delete the transmitter codes from memory.
* See the following pages for more detailed programming instructions.
1 Flash
Enabled
Type 1
Double Unlock
125ms
1 Flash
15 seconds
30 seconds
5ms
Trunk Release
Manual
1 Flash
Type 1
Negative
Type 1
4 Min
10 seconds
Active
Press twice
1 Flash
Low Idle Learn
Reduced by 10%
Increased by 10%
INSTALL MANUAL
2 Flashes
Lock Only
Type 2
3 second
750ms
2 Flashes
5 seconds
(-) Park Light
50ms
Garage Door
Auto Reservation
2 Flashes
Type 2
15 second
Type 2
45 Min
3 seconds
Passive
Press once
2 Flashes
PAGE 15
3 Flashes
Disabled
All Honks
3/4 second
3 Flashes
(+)Park Light
10ms
Car Finder
3 Flashes
Normal
Gas/Positive
Rearm
15 Min
5 seconds
GWR
3 Flashes
Advertisement
Table of Contents
