Table of Contents
Advertisement
INSTALL MANUAL
PAGE 18
Menu 3- Starter Settings
Ignition 3x
On/Off
On/Off On
Setting 1 Special Door Lock/Unlock Operations
1) Type 1
1 Flash/Honk
2) Type 2
2 Flashes/Honks
*3) Type 3
3 Flashes/Honks
Press & Release the Program Button 1 Time (Setting 1) Confirmed with 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 Gas/Diesel Mode
1) (+) Input
.2) Time Delay
*3) Gas/ (-) Input
Press & Release the Program Button 2 Times (Setting 2) Confirmed with 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 Gas/Diesel Mode
1) (-) Input
2) Time Delay
*3) Gas/ (+) Input
Press & Release the Program Button 2 Times (Setting 2) Confirmed with 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step
NOTE: Setting 2 will vary depending on the board layout 12xx or 13xx series..
Setting 3 Rearm Output (Auxiliary Connector Pin 1)
1) Type 1
2) Type 2
*3) Factory Re-arm
Press & Release the Program Button 3 Times (Setting 3) Confirmed with 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
Press and
Press and
Release the
Release the
Program
Button
Menu 3
Unlock before start. Lock pulse after start and shutdown.
Lock pulse ONLY after remote start shutdown.
Default Lock/ Unlock Pulses.
(Auxiliary Connector Pin 12, 12xx series)
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
(Auxiliary Connector Pin 12, 13xx series)
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
Press and Release
the Program Button
# of Times for
button for
Setting Chosen
(+) Glow Plug input. Waits maximum 30 seconds
Waits for approximately 15 seconds.
Waits 2 seconds if no diesel input is detected.
(-) Glow Plug input. Waits maximum 30 seconds.
Waits for approximately 15 seconds.
Waits 2 seconds if no diesel input is detected.
Pulse after start and with lock.
Pulse after start only.
Pulse with lock and after starter shutdown.
REMOTE VEHICLE STARTER
Press and Hold
the Program Button
to Change Option
(Factory Alarm Rearm).
.
Advertisement
Table of Contents
