Ultra Start 12xx Series Install Manual page 7

REMOTE VEHICLE STARTER
Wiring Diagram
*The centre pin of the keyless entry harness is ONLY available with plug-in
devices such as the VP-1, DL-3, DL-7 and Data Bus Modules.
Overloading this output will damage the remote starter.
Door Lock Output (-)250ma
12v Output (+)250ma
Door Unlock Output (-)250ma
ACTIVE RF ANTENNA**
**The antenna MUST be connected for the system to operate
(-) Input Trigger (13xx Series Only)
Ground While Running Output (-)250ma
Ground Output (-)250ma
12Volt Output (+)250ma
NOTE: The 2 pin white and 3 pin white auxiliary connectors are not
available on the 12xx series.
Output on White wire Jumper position
Second Starter
Second Accessory
Second Ignition
NOTE: The jumpers control the output from the WHITE wire on the
main 6- pin harness. This is an 30amp relayed output.
*The factory default setting of the Selectable Output jumper is position #3.
(see notes above)
Status Led's
Position 1
Position 2
Position 3
GREEN
* RED*
BLUE
Program Button
WHITE/VIOLET
BLACK
RED
1 2 3
INSTALL MANUAL
PAGE 7
1
2
3
1
2
3
4
1
2
1
2
3
Jumpers