Table of Contents
Advertisement
REMOTE VEHICLE STARTER
Quick View Programming
* See the following pages for more detailed programming instructions.
Menu 1 -Press Lock
1 Ignition Lock
2 Horn Honk
3 Lock&Unlock
4 Unlock/Disarm
5 Auxiliary Outputs
Menu 2 -Press Unlock 1 Flash
1 Secure Service Mode 15 seconds
2 Park Light Output
3 Horn Timing
4 Button #4
5 Reservation Mode
Menu 3 -Press Start
1 Lock/ Unlock Type
2 Gas/ Diesel
3 Rearm Output
4 Run Time
5 Crank Time
6 Starter Disable/ GWR Active
7 Safety Start Mode
Menu 4 -Press #
1 Low Idle Learn
2 Adjust For Over Crank
3 Adjust For under Crank
**Bold type indicates settings that are Factory Default.
System Reset
The system reset will clear any changes made to the Program Menu's as well as the
Tach setting. When the system reset is complete the system must be Tach learned
before the remote starter will operate.
1) Turn the ignition key from "Off" to "On" 3 times, ON-OFF-ON-OFF-ON within three
seconds. (Leave the key in the ON position)
2) Press and release the Program Button located on the antenna. The park lights will
turn on and the horn (optional) will honk one time.
3) Then press and hold the Program Button until the park lights flash and the horn
(optional) will honk 3 times slowly to confirm system reset.
System is now reset to factory defaults.
Note: System Reset does not delete the transmitter codes from memory.
1 Flash
2 Flashes
Enabled
Type 1
Type 2
Double Unlock
125ms
Type 1Type 2
Disabled
2 Flashes
5 seconds
30 second
(-) Park Light
5ms
Trunk Release
Garage Door
Manual
Auto Reservation
1 Flash
2 Flashes
Type 1
Type 2
Negative
15 second
Type 1
Type 2
4 Min
45 Min
10 second
3 seconds
Passive
Press twice
Press once
1 Flash
Low Idle Learn
Reduced by 10%
Increased by 10%
INSTALLATION MANUAL
Lock Only
3 second
750ms
50ms
Page 15
3 Flashes
Disabled
All Honks
.75 second
3 Flashes
Park Light Flash
10ms
Car Finder
3 Flashes
Normal
Gas/ Positive
Rearm
15 Min
5 seconds
GWR
Advertisement
Table of Contents
