Clutch Bypass - Ultra Start 12xx Series Install Manual

REMOTE VEHICLE STARTER
Manual Transmission "M" Models
Never install an automatic transmission remote starter into a manual transmission
vehicle!!! Doing so may result in serious injury or death. Do not install remote starters
in convertible vehicles! The following wires must be connected in addition to the
basic remote starter installation.
Park Brake Input- This wire is located at the park brake switch. The wire will
(-) Door Pin Input- A negative door pin wire will be (+) or neutral when the
(+) Door Pin Input- A positive door pin wire will be (-) or neutral when the door
NOTE: Blue/White must be connected on "M" series.
If any Door Pin Switches or the Park Brake Switch is not working correctly...
"DO NOT INSTALL UNTIL THE VEHICLE IS REPAIRED!!!"
Clutch Bypass - In most cases the clutch switch will need to bypassed during
remote starting. This is a temporary bypass, the clutch switch should never be
disconnected or altered to not work as it is indented to"As a Safety Switch". The
clutch switch is usually a 2 wire switch mounted directly to the clutch pedal. There
are several types of clutch switches that operate in one of the following ways:
Type 1 - Starter Wire Bypass - The starter wire travels form the key switch
through the clutch switch to the starter motor. Connect the remote starters
Starter Output wire directly to the starter motor side of the clutch switch.
Type 2 - Negative (High Current) - This switch grounds the factory starter relay
and allows the vehicle to start. Connect a relay to ground the output side
of the clutch switch wire when the remote starter is activated. The starter
wire is connected at the ignition switch.
Type 3 - Connect Switch - Install a relay to connect the two wires at the switch
when the remote starter is activated. The starter wire is connected at the
ignition switch.
Type 4 - Disconnect Switch Install a relay to disconnect one of the wires at
the clutch switch. The starter wire is connected at the ignition switch.
Testing for the correct wire is critical! Never connect to a circuit if you are not sure
of it's operation. Contact your dealer or technical support for more information.
switch to (-) when the park brake is applied.
Never connect the Black/White wire straight to a ground!!!
door is closed then switch to (-) when the door is opened.
Always ensure that all the vehicles doors are sensed.
is closed then switch to (+) when the door is opened.
Always ensure that all the vehicles doors are sensed.
INSTALL MANUAL
PAGE 11