Defining A Recording Schedule - Interlogix TruVision 360° Configuration Manual

Figure 16: Storage Management menu
To format the storage devices:
1. Click Configuration
2. Check the HDD No.
3. Click Format. A window appears to check your formatting permission.
4. Click OK to start formatting.
To define the quota for record and snapshots:
1. Input the quota percentage for picture and for record.
2. Click Save and refresh the browser page to activate the settings.

Defining a recording schedule

You can define a recording schedule for the camera in the "Record Schedule" window.
The recording is saved on to the SD card or NAS in the camera. The camera's SD card
provides a backup in case of network failure.
The selected recording schedule applies to all alarm types.
Pre-record time
The pre-record time is set to start recording before the scheduled time or the event. For
example, if an alarm triggers recording at 10:00, and the pre-record time is set as 5
seconds, the camera starts to record at 9:59:55. The pre-record time can be configured
as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s or not limited.
Post-record time
The post-record time is set to stop recording after the scheduled time or the event. For
example, if an alarm triggered recording ends at 11:00, and the post-record time is set
30
> Storage > Storage
tab to select the storage.
Management.
TruVision 360° Camera Configuration Manual