Steps For Finalizing The Installation - Travis Industries 864 HO NB Installation Manual

Steps for Finalizing the Installation

1. Remove the glass frame (see page 39).
NOTE: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass frame removed). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3. Make sure the two accent light bulbs are in place.
NOTE: Take care to not touch the bulb with your fingers (use a cloth or paper towel).
4. Install the required firebacks (see page 41).
5. Install the burner and media (logs or stones). See the instructions included with the burner and media.
6. Replace the glass frame.
7. Install the four AA batteries (included in the owner's pack) into battery holder (see the illustration below). The AA
batteries act as a power backup in case the household (AC) power goes out. Install the 9v battery (included in
the owner's pack) into control panel light assembly (see the illustration below). The battery holder is held in
place with Velcro and may be removed for easier access.
Lift up and swing the lower
grill down to acces the area
below the firebox.
© Travis Industries
Installation
(for qualified installers only)
Swing the concealment
cover up and slide it back to
expose the controls.
AA Battery Tray
4120327
Battery Holder for
Control Panel Lights
AA
Battery
Holder
100-01290_000
37