Optional Equipment
17
Attach the included velcro to the bottom of the fan control module and to the base of the fireplace
near back left of the fireplace. Slide the fan controller into place and secure using the velcro (see
Figure 26).
18
Pull the "RECEIVER" connector through the control panel and attach to the receiver (see Figure
27). Then attach the receiver to the control panel with the two #8 machine screws (see Figure 28).
19
Place batteries into the receiver and transmitter (see Figure 29). Calibrate the receiver to the
transmitter (see Figure 30 - use a paperclip to press the "PRG" button, let it beep, then press any
button on the transmitter – the receiver should beep 5 times – see the operating instructions for
further details).
© Travis Industries
(for qualified installers only)
Figure 27
Figure 29
4120327
55
Figure 26
Figure 28
Figure 30
100-01290_000