Table of Contents
Advertisement
Finalizing the Installation
Steps for Finalizing the Installation
1.
Remove the glass (see page 39).
NOTE:
If using propane (LP) convert the appliance prior to installing the logs.
2.
We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected
once it enters the firebox, ensuring gas does not build up.
NOTE:
If using firebacks, install them prior to adjusting the accent light deflectors.
3.
Carefully bend the accent light deflectors outwards to 45 (see "a" below). Take care to prevent damage to the
bulbs. Make sure the two accent light bulbs are in place. The assembly may be removed for bulb replacement
(see "b" below).
NOTE: .Take care to not touch the bulb with your fingers (use a cloth or paper towel).
4.
Install the four AA batteries (see illustration below). The AA batteries act as a power backup in case the
household (AC) power goes out and are required for operation.
illustration below). Synchronize the transmitter to the IFC (see the Owners Manual).
© Travis Industries
(for qualified installers only)
Install three AAA batteries into the remote (see
4140729
a
37
b
100-01404
Advertisement
Table of Contents
