52
Optional Equipment
9
Use the included torx wrench to remove the stock regulator (see Figure 13). These items may be
discarded.
10
The stepper motor (adjustable regulator) has an installation sheet included with it – make sure to
follow all of the directions. Place the stepper motor on the gas control valve (see Figure 14) –
MAKE SURE IT IS CORRECTLY ORIENTED. Secure using the screws included with the motor
(see Figure 15) – tighten to 25 Lb-inches. Leak test this area after installation to verify proper
installation.
11
Place the GreenSmart wiring harness in front of the fireplace, noting the position of each
connector (see .Figure 16).
© Travis Industries
(for qualified installers only)
Figure 14
4120327
Figure 13
Figure 15
Figure 16
100-01290_000