Installation; General Installation Precautions; Electric Power Supply; Environment Conditions - Olivetti PR2 Service Manual

3. INSTALLATION

3.1 GENERAL INSTALLATION PRECAUTIONS

To ensure that the printer operates at its best and to avoid servicing that does not arise from the
product, the specifications indicated in the following sections must be observed.

3.1.1 ELECTRIC POWER SUPPLY

Check the socket the printer is connected to ground and is able to supply the power required by the
machine. A socket without ground connection could cause operating faults and create safety hazards.
Do not connect the printer to lines in common with equipment that could cause electrical disturbances
and excessive voltage fluctuation (fans, air conditioners, powerful photocopying machines, motors for
lifts, TV radio transmitters, signal generators, high frequency safety devices and so forth).
Usual office equipment (calculators, typewriters, small photocopying machines, terminals and PC)
can be connected on the same line as long as they do not cause high electrical disturbance.

3.1.2 ENVIRONMENT CONDITIONS

The environment conditions in which the product can remain indefinitely are those indicated by the
o
AB quality targets (normal office temperature conditions 15/35 C, 15/85% RH).
Avoid, both when stored and when operating, that the environment conditions undergo changes that
cause condensation.
Dust, dirt and smoke can cause the parts in motion to wear excessively, short circuits (with a high
degree of humidity) and read/write errors during the different operations.
High temperatures and low humidity can cause problems due to static electricity.

3.1.3 MOVING THE MACHINE

The printer must be installed on a flat surface, without vibrations. Do not place the printer near to air
vents, heat sources or in direct sunlight.
Do not obstruct the printer ventilation slots.
If the machine is inserted into a fitting, make sure that it has good ventilation to prevent overheating
that would damage the printer.
Install the machine so that any papers jammed along the document path can be removed.
683311W Service Manual 3-1