Disassembling/Reassembling The Rear Photosensor - Olivetti PR2 Service Manual

9.2.11 DISASSEMBLING/REASSEMBLING THE REAR PHOTOSENSOR

- Remove the mechanical assembly (section 9.2.3)
- Remove the rear protection shield after removing the two screws (1)
- Remove the rear photosensor flat cable by releasing the two plates (2) that are snapped into the
plastic supports.
Note: If the photosensor is replaced, proceed with adjustment
at the end of reassembly.
683311W
1
2
Fig. 9-12
Service Manual
2
4.4. (Photosensor Adjustment)
9-13