Adjusting The Left Print Margin - Olivetti PR2 Service Manual

4.6.4 ADJUSTING THE LEFT PRINT MARGIN

This adjustment sets the distance between the left edge of the document and the first print character.
The left margin value will always be used without the need for set-up configurations.
Proceed as follows to make this adjustment:
1. Power on the printer with its cover open and while holding down the three console keys.
2. Wait for an acoustic signal to indicate that the printer has switched into the adjustment mode and
close the cover.
3. Press the "Local" key.
4. Press the "Station 2"key.
5. The three console keys are activated after this phase. Pressing the "Station 1" key will reduce the
left margin while "Station 2" will increase this margin.
6. Insert an A4 sheet of paper into the front slot to check the status of the current left margin. This
check is made through a specific test that prints the current left margin.
7. Press "Station 1" and/or "Station 2" to move the left margin further to the left or right.
8. Repeat steps 6. and 7. until the adjustment is completed.
9. Press the "Local" key to permanently store the left margin and to automatically move on to the next
adjustment.
683311W
Service Manual
4-37