Machine Installation; Off-Line Tests; Starting The Print Test - Olivetti PR2 Service Manual

3.2.2 MACHINE INSTALLATION

Position the machine where it will be operating, checking that the conditions set out in section 3.1 are
respected.
Make sure that the voltage indicated on the network plate is the same as the local power supply.
Connect the main cable and power on the printer.
Verity that it is powered by checking the mechanical reset and lighting up of the ON LED on the
console.
If other LEDs remain lit other than the ON LED, consult section 2.2.3 "Error Messages".

3.3 OFF-LINE TESTS

To check the printer functionality before connecting it to the system, a print test can be made.

3.3.1 STARTING THE PRINT TEST

- To start the test, proceed as follows:
- Power off the printer
- Power up the machine keeping the ST2 key on the console pressed down
- After the reset, insert an A4 sheet into the infeed device so as to activate the paper alignment
photosensor
- The machine will automatically feed in the sheet and after printing will expel it
- To repeat the print-out insert a new sheet into the machine.
3-4 683311W