Olivetti PR2 Service Manual page 66

(Only if the horizontal magnetic unit option is present)
OPTION HORIZONTAL MSRW
STANDARD
(Only for STANDARD = IBM 3604)
END-SENTINEL
DISPLACEMENT
DUPLICATE
RETRY
STRIPE HANDLING
(Only if the vertical magnetic unit is present)
OPTION VERTICAL MSRW
DENSITY
RETRY
Note: If the right vertical magnetic unit option is present, SIDE = R must be selected so that the
option can be handled correctly.
PNS SELECTION:
PNS # 3416:
PNS # 3517:
(if) PNS # 3517:
CPI 15:
4-14
DIN/ISO - ANSI
- IBM 3604
C - F
STANDARD -
+10 - +20
Y - N
3 - 1
NORMAL -
FAST
80 BPI - 160 BPI
3 - 1
N - Y
N - Y
N - Y
Y
N - Y
Informs that the option is installed. If the MICR option
is present, + MICR will be written alongside
"...........MSRW".
Sets the magnetic standard.
Sets the end code.
Sets the position of the magnetic stripe.
Sets the printer for field duplication.
Sets the number of read attempts before an error
condition is signalled.
Allows the normal of fast handling of the magnetic
stripe.
Informs that the option is installed.
Sets the data density in bits per inch.
Indicates the number of read attempts before an error
condition is signalled.
Selecting (Y) grants access to the PNS selection
menu in the Olivetti PR40+ environment.
Enables or disables a check on the magnetic stripe's
two recorded fields.
By selecting Y the selection "CPI 15: y/n" will appear.
With this selection, the default spacing at power up
will be 15 cpi, otherwise it will correspond to the value
set for the CPI parameter. Enabling this PNS will
activate the ESC a 3 command for the SW selection
of a 15 cpi spacing.
15 cpi pitch selection. By selecting "Y" the spacing at
power up will be 15 cpi which becomes prioritary with
respect to the value set for the standard "CPI"
parameter mentioned earlier. In this case, during
SELF-TEST printing the standard "CPI" parameter
will no longer be printed.
683311W