REAR WHEEL AND BRAKE DISC
EAS00567
CHECKING THE REAR WHEEL DRIVE HUB
1. Check:
S rear wheel drive hub
S rear wheel drive hub dampers
EAS00572
INSTALLING THE REAR WHEEL
1. Lubricate:
S drive shaft splines
2. Lubricate:
S wheel axle
S wheel bearings
S oil seal lips
2. Install:
S rear wheel assembly
a. Install the rear wheel assembly 1 with the
b. After installation of the rear axle shaft 3 ,
c. To make sure the caliper bracket mounts on
NOTE:
The holder should installed with the punch mark
a facing upper.
d. Tighten the rear gear housing bolts, with spe-
e. Tighten the nut of rear axle shaft with speci-
6-14
Cracks/damage ! Replace.
Damage/wear ! Replace.
Recommended lubricant
Molydenum disulfide grease
Recommended lubricant
Lithium soap base grease
rear brake caliper bracket 2 and hold the
bracket to keep the specified position.
slide the wheel assembly to forward direc-
tion.
the swingarm and then, fix the holder of swin-
garm temporally.
cified tightening torque.
Rear gear housing bolt
90 Nm (9.0 mSkg)
fied torque.
Wheel axle nut
107 Nm (10.7 mSkg)
CHAS