Removing And Installing The Ring Gear Bearings - Yamaha XVS1100(L) Service Manual

SHAFT DRIVE
EAS06725
REMOVING AND INSTALLING THE RING
GEAR BEARINGS
1. Remove:
S collar 1
S oil seal 2
S bearing 3
(with an appropriate press tool 4 and an ap-
propriate support for the final drive housing)
2. Check:
S bearing
Damage ! Replace.
3. Remove:
S bearing 1
a. Heat the final gear case to approximately
150 _C (302 _F).
b. Remove the bearing outer races with an ap-
propriately shaped punch 2 .
c. Remove the inner race from the final drive
pinion gear.
NOTE:
The removal of the final drive pinion gear bear-
ing is a difficult procedure and is rarely neces-
sary.
4. Install:
S bearing (New)
a. Heat the final gear case to approximately
150_C (302_F).
b. Install the bearing outer races with a socket
or appropriate tool that matches the diameter
of the races.
c. Install the inner race onto the final drive pin-
ion gear.
6-82
CHAS