ADJUSTING THE REAR BRAKE LIGHT SWITCH/
CHECKING THE BRAKE HOSES
EAS00128
ADJUSTING THE REAR BRAKE LIGHT
SWITCH
NOTE:
The rear brake light switch is operated by move-
ment of the brake pedal.
The rear brake light switch is properly adjusted
when the brake light comes on just before the
braking effect starts.
1. Check:
S rear brake light operation timing
Incorrect ! Adjust.
2. Adjust:
S rear brake light operation timing
a. Hold the main body 1 of the rear brake light
switch so that it does not rotate and turn the
adjusting nut 2 in direction a or b until the
rear brake light comes on at the proper time.
! Brake light comes on
Direction
a
! Brake light comes on
Direction
b
EAS00131
CHECKING THE BRAKE HOSES
The following procedure applies to all of the
brake hoses and clamps.
1. Check:
S brake hose
Cracks/damage/wear ! Replace.
2. Check:
S brake hose clamp
Loose connection ! Tighten.
3. Hold the motorcycle upright and apply the
brake.
4. Check:
S brake hose
Activate the brake several times.
Brake fluid leakage ! Replace the damaged
hose.
Refer to "FRONT AND REAR BRAKES" in
chapter 7.
3-25
INSP
ADJ
sooner.
later.