Checking The Bearing And Oil Seals; Installing The Crankshaft - Yamaha XVS1100(L) Service Manual

CRANKSHAFT AND CONNECTING RODS
EB412440
CHECKING THE BEARINGS AND OIL
SEALS
1. Check:
S bearings
Clean and lubricate the bearings, then rotate
the inner race with your finger
Rough movement ! Replace.
2. Check:
S oil seals
Damage/wear ! Replace.

INSTALLING THE CRANKSHAFT

3. Install:
S connecting rod bearings 1
NOTE:
S Align the projection a of the bearings with the
notches b in the connecting rod cap.
S Install each bearing in its original place.
4. Install:
S connecting rods 1
NOTE:
S The stamped "Y" mark a on the connecting
rods should face towards the left side of the
crankcase.
S Install each connecting rod in its original place.
5. Install:
S connecting rod cap 1
NOTE:
Be sure that the characters a on the side of the
cap and connecting rod are aligned.
6. Tighten:
S nuts (connecting rod cap)
NOTE:
Apply molybdenum disulfide grease to the rod
cap bolt threads and nut surfaces.
4-65
ENG
48 Nm (4.8 mSkg)