WATER TANK HOUSING (TDC44)
Removing water tank housing
1. Pull out the water tank.
2. Remove the three screws at the rear edge and
lift off the top cover.
3. Remove the hoses.
4. Unscrew the 2 screws in the panel and the
screws in the rear panel.
5. Push the housing back and lift it out.
Installing water tank housing
6. Offer up the housing to its correct position.
7. Secure it to the panel and the rear panel.
8. Refit the hoses.
9. Fit the top cover.
10. Insert the water tank.
Changing the water tank handle
1. Pull out the water tank.
2. Remove the two plastic clips on the undersi-
de of the tank with the aid of a screwdriver.
3. Pull the handle off the tank.
4. Install the new handle by threading it through
the groove in the container. Press it to snap it
into place.
5. Refit the water tank.
4
5
2
SERVICE
3
4
6
3
69