External Fan Housing (Tdc44); Removing The External Fan Housing; Installing The External Fan Housing; Cleaning The External Fan Wheel - Asko TDC33 Service Manual

EXTERNAL FAN HOUSING (TDC44)

Removing the external fan housing

1. Remove the rear panel in accordance with the
section "Rear panel -
2. Unclip the external fan housing suction side.
3. Unscrew the external fan wheel and remove
it.
4. Lift and pull towards you the external fan
housing motor side.

Installing the external fan housing

5. Push the external fan housing motor side on
to the motor shaft until the snap fastener locks
at the bottom.
6. Install the fan wheel.
7. Install the external fan housing suction side.
IMPORTANT
The snap fasteners must clip securely into place.
8. Install the rear panel in accordance with the
section "Rear panel -

Cleaning the external fan wheel

1. Open the cover and pull out the condenser
assembly.
2. Put you arm in, bend the pins out of the way
and clean inside.
NOTE
You can also clean the fan wheel by removing the
rear panel.
removing...".
installing...".
3
SERVICE
2
4
1
45