Changing The Rear Felt Strip Seal; Changing/Cleaning The Heating Element - Asko TDC33 Service Manual

Changing the rear felt strip seal

1. Remove the rear panel in accordance with the
section "Rear panel -
2. Lift off the felt strip seal.
3. Thread the new felt strip into place.
4. Tighten the tensioning band around the felt
strip, using the special tool.
5. Fold over the felt strip.
3. Fit the rear panel in accordance with the sec-
tion "Rear panel - installing...".

Changing/cleaning the heating element

1. Remove the three screws at the rear edge and
lift off the top cover.
2. Remove the screws that secure the rear panel
to the sides and bottom.
3. Remove screws that secure the inner and out-
er rear panels, along with the cable clamp.
4. Lift off the outer rear panel.
5. Unscrew the heating element.
6. Install a new heating element or clean the old
one.
7. Secure the heating element.
8. Put the outer rear panel in place.
9. Secure the rear panels to each other.
10. Secure the rear panels to the machine.
11. Fit the top cover.
removing...".
3
4
5
SERVICE
5
2,3
37