Humidity Sensor; Removing The Humidity Sensor; Installing Humidity Sensor - Asko TDC33 Service Manual

HUMIDITY SENSOR

Removing the humidity sensor

1. Remove the three screws at the rear edge and
lift off the top cover.
2. Take off the bottom cover (snap fasteners).
3. Use a screwdriver to remove the plugs.
4. Remove the cover for the fan housing (4 snap
fasteners and 1 screw).
5. Unscrew the 2 screws that secure the sensor to
the cover.
6. Lift out the humidity sensor.
NOTE
To check if the humidity sensor is faulty, a new
sensor can be installed in the fan housing, with its
wire taken outside the machine to the control
board/programmer.
7. Remove the drum in accordance with the sec-
tion "Drum - removing...".
8. Remove the humidity sensor from the con-
trol board and the wiring from the front fra-
me.
9. Pull out the sensor's connecting cable.

Installing humidity sensor

10. Route the humidity sensor's connecting cable
up to the control board.
11. Secure the cable in the cable clamps and con-
nect the plug to the control board.
12. Install the drum in accordance with the sec-
tion "Drum - installation...".
13. Install the strip seal on the humidity sensor.
14. Secure the humidity sensor inside the cover
and protection.
15. Install the plugs and the cover for the fan hou-
sing.
16. Install the bottom and top covers.
IMPORTANT
Always install new strip seal when the humidity
sensor is changed.
2
3
4
6
SERVICE
49