Table of Contents
Advertisement
CARE AND CLEANING
EMPTYING THE CONDENSED WATER
CONTAINER
If you have not connected the machine to a separate
drain the condensed water container must be emptied
after each load. Remove the condensed water container,
empty out the water and replace the container.
If the condensed water container becomes full to overfl
owing, the program is interrupted and "Over Flow"
appears on the display. Empty the container and press
the Start button to restart the program.
For connection to a separate drain, see the installation
instructions in the set of documents.
NOTE!
Empty the condensate tank after each drying cycle.
NOTE!
The dryer must not be used without the condenser unit
in place.
16
Customer Care Center, 1-800-898-1879, www.askousa.com
CLEANING THE EVAPORATOR FILTER
AND EVAPORATOR
Clean the evaporator and the evaporator fi lter at the
intervals shown on the machine's display or more often.
1. Turn off the Main power switch and open the outer
door.
2. Remove the plinth.
3. Open the heat pump door.
4. Pull out the fi lter by lightly pressing the fi lter support
downwards.
Advertisement
Table of Contents
