Emptying The Condensed Water Container; Cleaning The Evaporator Filter And Evaporator - Asko Professional TDC145HPS Operating Instructions Manual

CARE AND CLEANING
EMPTYING THE CONDENSED WATER
CONTAINER
If you have not connected the machine to a separate
drain the condensed water container must be emptied
after each load. Remove the condensed water container,
empty out the water and replace the container.
If the condensed water container becomes full to
overfl owing, the programme is interrupted and "Over
Flow" appears on the display. Empty the container and
press the Start button to restart the programme.
For connection to a separate drain, see the installation
instructions in the set of documents.
NOTE!
Empty the condensate tank after each drying cycle.
NOTE!
The dryer must not be used without the condenser unit
in place.
14
CLEANING THE EVAPORATOR FILTER
AND EVAPORATOR
Clean the evaporator and the evaporator fi lter at the
intervals shown on the machine's display or more often.
1. Turn off the Main power switch and open the outer
door.
2. Remove the plinth.
3. Open the heat pump door (on some models is
necessary to use socket wrench).
4. Pull out the fi lter by lightly pressing the fi lter support
downwards.
5. Remove the sponge fi lter (B) from the fi lter support
(A). Clean it with a vacuum cleaner and wash it under
running water.