Changing The Overheating Protection Device - Asko TDC33 Service Manual

SERVICE

Changing the overheating protection device

1. Remove the three screws at the rear edge and
lift off the top cover.
2. Remove the screws that secure the rear panel
to the sides and bottom.
3. Remove the screws that secure the inner and
outer rear panels, along with the cable clamp.
4. Lift off the outer rear panel.
5. Unscrew the overheating protection device.
6. Fit the new overheating protection device.
7. Secure the overheating protection device.
8. Put the outer rear panel in place.
9. Secure the rear panels to each other.
10. Secure the rear panels to the machine.
11. Fit the top cover.
38
5
2,3