Motor; Removing The Motor; Installing The Motor - Asko TDC33 Service Manual

SERVICE

MOTOR

Removing the motor

1. Remove the drum in accordance with the sec-
tion "Drum - removing...".
2. Take off the bottom cover (snap fasteners).
3. Remove the fan housing cover (4 snap fasten-
ers and 1 screw).
4. Unscrew the fan wheel.
5. TDC44: Remove the external fan housing in
accordance with the section
sing - removing..."
6. Disconnect the wiring in the switch housing
on the motor, and the earthing wire.
7. Unscrew the 4 screws securing the motor to
the bottom plate.
NOTE
To gain access to the screws the belt tensioner can
be lifted off.
8. Lift out the motor.

Installing the motor

9. Align the motor with the four holes and se-
cure it.
10. Connect the wiring.
IMPORTANT
Don't forget to put the belt tensioner back.
11. Install the fan wheel and the cover for the fan
housing.
12. Put the bottom cover back.
13. TDC44: Install the external fan housing in
accordance with the section
sing - installation..."
14. Install the drum in accordance with the sec-
tion "Drum - installation...".
46
"External fan hou-
steps 2-4.
"External fan hou-
steps 5-7.
2
3
4
5
6