Changing The Foam Rubber Seal; Changing The Bearing - Asko TDC33 Service Manual

SERVICE

Changing the foam rubber seal

1. Remove the 3 screws at the rear of the top
cover and lift it off.
2. Remove the screws that secure the rear panel
sides and bottom.
3. Remove the screws that secure the inner and
outer rear panels.
4. Lift off the outer rear panel.
5. Change the foam rubber seal.
6. Put the outer rear panel in place.
7. Secure the rear panels to each other.
8. Secure the rear panels to the machine.
9. Fit the top cover.

Changing the bearing

1. Remove the rear panel in accordance with the
section "Rear panel -
2. Remove the screws that secure the inner and
outer rear panels, also the cable clamp.
3. Lift them apart.
4. Change the bearing.
5. Put the inner rear panel and the bearing on
the shaft.
6. Offer up the outer rear panel and secure the
inner rear panel to it, along with the cable
clamp.
WARNING
It is important that the wiring bundle runs along
its groove.
7. Remove the special tool.
8. Secure the rear panel to the side panels and
bottom. Install the remaining wiring in ac-
cordance with the electrical schematic diagram
and refit the disconnected cables, and the top
cover.
9. Tighten the centring nut.
36
removing...".
2,3
5
4