Right Hanging To Left Hanging - Asko TDC33 Service Manual

Right hanging to left hanging

1. Keep the front door closed, it will be held in
position by the door magnet.
2. Remove the bottom cover.
3. TDC44: Open the condenser housing co-
ver.
4. Remove the 3 screws that secure the hinge
fixing and the lower screw that secures the
front panel.
5. Tilt the hinge fixing so that it comes free from
the hinge socket in the front door.
6. Tighten the lower screw securing the front
panel.
7. Lift down the front door.
8. Change the hinge pin over.
9. Then change over the hinge pin for the up-
per hinge.
10. Then change over the plastic plugs and the
hinge sockets located on the upper and lo-
wer edges of the front door respectively. Use
a flat-bladed screwdriver.
11. Half unscrew the two screws on the sides of
the front door.
12. Then take out the door magnet and cover
washer.
Right side: Push the magnet/washer upwards
and pull them out.
Left side: Push the magnet/washer down-
wards and pull them out.
13. Fit the door magnet and cover washer.
14. Screw in the two screws on the sides of the
front door.
15. Keep the front door in place with the door
magnet.
3
5
8
10
DOOR HANGING
4
10
12
11
17