Changing The Float - Asko TDC33 Service Manual

SERVICE

Changing the float

1. Remove the drum in accordance with the sec-
tion "Drum - removing...".
2. Remove the external fan housing in accordance
with the section "External fan housing - remo-
ving...".
3. Remove the snap fasteners with the aid of a
screwdriver and lift out the condenser assem-
bly.
4. Remove the 4 screws that secure the conden-
sed water pump.
5. Remove the 7 screws from around the edge.
6. Remove the foam rubber seal.
7. Take apart the two halves of the housing.
8. Change the float.
9. Screw the housing halves together.
NOTE
We recommend changing the foam rubber seal
every time the housing is dismantled.
10. Install the external fan housing in accordance
with the section "External fan housing - in-
stallation...".
11. Install the drum in accordance with the sec-
tion "Drum -installation...".
68
7
5
6
3
8
5
4
4