Motor Dryer - Asko TLS752 Manual

1. Function
• The motor rotates the drum using the belt as well as the fan to expel wet air.
• This is a shunt AC motor. When the motor begins to run, a centrifugal switch shorts out the operation coil.
• The centrifugal switch also supplies power to the heater. Thus, if the motor stops, the heater goes off also.
Fan connection axis
2. Specification
• Shunt type 1/3 HP AC motor with centrifugal switch
• Rotational speed : more than 1600 rpm with load
• No load : 190W, 4.9A at 120V
• Full load : 555W, 6.1A at 120V
• Type name : S58NXSDD-6989
3. Checking method of mal-function
• If the drum rotates and exhaust air is expelled as soon as you start the unit, the motor is in normal operation.
• If the drum fails to rotate;
① Remove Plate T and check if the belt is damaged.
② Check if the door switch is in normal operation.
③ Remove the drum and check the thermostat fan.
④ Check the belt switch.
⑤ Run the unit while you press the lid of the belt switch and see if the motor starts operating.
• If a fault is found in any part mentioned above, replace it and check the operation of the motor (5).
• If no fault is found but the motor still fails to operate5, replace the motor.
4. Procedure of replacement
① Plate Top Remove
② Panel F Ass'y Remove
③ Cabinet Front Ass'y Remove
④ Frame Upper Remove
⑤ Drum Ass'y Remove
⑥ Cover Fan Remove

Motor Dryer

Belt operation axis
58
Part Code : 36189L5D0
Inner wiring
Belt assembly