Cleaning The Fan; Cleaning The Condenser - Asko T701 Use And Care Manual

CLEANING THE FAN

The fan should be cleaned at least once a year. If you
have pets, you should clean it more often. To clean the
fan, follow the steps below:
1. Turn off the main power to the machine.
2. Remove the two 20 torx
screws on the bottom of the
front panel then grasp the
bottom of the panel and pull
it forward and down.
3. Unscrew the 10 torx safety
screw on the bottom of the
fan cover and fold out the four
tabs.
4. Remove the fan cover.
5. Hold the fan in place while
you unscrew the nut.
6. Pull out the fan and clean it with
a brush and water.
7. Replace the fan and screw
the nut securely.
8. Replace the fan cover and
fold the lugs back into place.
Replace the safety screw.
9. Replace the front panel.

CLEANING THE CONDENSER

The condenser should be cleaned on a regular basis,
preferably monthly. If you have pets, you should probably
clean it more often. To clean the condenser, follow the
steps below:
1. Turn off the main power to the machine.
2. Remove the two 20 torx
screws on the bottom of the
front panel then grasp the
bottom of the panel and pull
it forward and down.
3. Turn the levers on the
condenser cover counter-
clockwise to release it then
pull it down.
4. Pull out the condenser.
5. Spray the filter with warm water
until all of the lint is removed.
WARNING!
Do not put the condenser
into a dishwasher. Do not
use any sharp metal objects
or a wire brush to clean the
condenser. Also, do not poke
anything between the fins.
6. Make sure the side marked
"UP" does face up and carefully
replace the condenser into the
unit.
7. Close the condenser cover.
8. Replace the front panel.
9. Turn back on the main power.
Page 19