[Initial Start Up]; [Projection Method]; [High Altitude Mode]; [All] - Panasonic PT-VW345NZ Operating Instructions Manual

3) Press as to select the [PROJECTOR ID].
f Select one from [ALL], and [1] to [6].

[ALL]

[1] - [6]
4) Press the <ENTER> button to set it.
f [PROJECTOR ID] is set.
Note
f The ID number can be set to [ALL], or from [1] to [6].
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or
computer control.
If multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors
with other ID numbers.
f Refer to "Setting the remote control ID numbers" (

[INITIAL START UP]

Set the method of start up when the power cord plugged into the AC outlet.
1) Press as to select [INITIAL START UP].
2) Press qw to switch the item.
f The items will switch each time you press the button.

[LAST MEMORY]

[STANDBY]
[ON]

[PROJECTION METHOD]

Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
1) Press as to select [PROJECTION METHOD].
2) Press qw to switch the item.
f The items will switch each time you press the button.

[FRONT/DESK]

[FRONT/CEILING]
[REAR/DESK]
[REAR/CEILING]

[HIGH ALTITUDE MODE]

Change the setting according to the altitude in which you use the projector.
1) Press as to select [HIGH ALTITUDE MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.

[OFF]

[HIGH1]
[HIGH2]
Note
f It is set to [OFF] when using the projector in the elevation of below 1 400 m. It is set to [HIGH1] when using the projector in
the elevation of above 1 400 m and below 2 000 m. It is set to [HIGH2] when using the projector in the elevation of above
2 000 m and below 2 700 m. Failure to do so may shorten the life of the internal parts and result in malfunctions.
f Do not set the projector in the elevation of 2 700 m or above, otherwise it may shorten the life of the internal parts and result
in malfunctions.
f When it is set to [HIGH1] or [HIGH2], the fan noise becomes louder and fan speed increases.
Chapter 4 Settings - [PROJECTOR SETUP] menu
Select when controlling projectors without specifying an ID number.
Select when specifying an ID number to control individual projector.
Æ
Starts in the condition that before disconnected the power cord or turn off the breaker.
Starts up in the standby mode.
Starts the projection immediately.
When installing the projector on the desk, etc. in front of the screen.
When installing the projector in front of the screen by using the Ceiling Mount Bracket for
Projectors (optional).
When installing the projector on the desk, etc. behind the screen (with a translucent screen).
When installing the projector behind the screen (with a translucent screen) by using the Ceiling
Mount Bracket for Projectors (optional).
When using the projector in the elevation of below 1 400 m.
When using the projector in the elevation of above 1 400 m and below 2 000 m.
When using the projector in the elevation of above 2 000 m and below 2 700 m.
page 29) for how to set the ID number on the remote control.
ENGLISH - 75