Panasonic PT-VW345NZ Operating Instructions Manual page 88

r [ENCRYPTION] setting
[NONE]
[WEP]
[TKIP]
[AES]
r When setting [OPEN] or [SHARED] as authentication and setting [WEP] as the encryption method:
[DEFAULT KEY]
[KEY1-KEY4]
r When setting [WPA-PSK] or [WPA2-PSK] as authentication method:
[KEY]
r When the authentication method is [WPA-EAP/WPA2-EAP], [WPA-EAP], [WPA2-EAP]:
[EAP]
[USE NAME]
[PASSWORD]
Note
f If you are unable to connect to the wireless LAN through the access point even after performing the steps in "Projector
Æ
settings" ( page 93), contact the manufacturer of the access point (Radio repeater).
f When using EAP, the projector needs to be set according to the setting of the RADIUS server. Check with the network
administrator for the setting of the RADIUS server.
f When using an EAP together with an access point with invalid SSID broadcast, select WAP-EAP or WAP2-EAP for the
authentication method even if the authentication method of the access point is WPA-EAP/WPA2-EAP.
f If USER1 ~ 3 use, you can not connect to the access point of stealth SSID configuration, please use it to cancel the stealth
setting. For details, please refer to the Operating Instructions of the access point.
5) Press as to select [OK], and press the <ENTER> button.
r Default setting of [USER1], [USER2], [USER3]
f The following settings are set before the projector leaves the factory.
88 - ENGLISH
Chapter 4 Settings - [NETWORK/USB] menu
Select when transmit without encryption. It is selectable only when
[AUTHENTICATION] is [OPEN] or [SHARED].
Select when Encryption is WEP.
Select when Encryption is TKIP.
Selectable when [AUTHENTICATION] is either [WPA-PSK], [WPA2-PSK],
[WPA-EAP], [WPA2-EAP].
Select when Encryption is AES.
Selectable when [AUTHENTICATION] is either [WPA-PSK], [WPA2-PSK],
[WPA-EAP], [WPA2-EAP].
Set 1 – 4 numerals for the default key.
Set a [WEP] key to the key number selected with [DEFAULT KEY].
Either the 64-bit or 128-bit WEP key can be set. For the 64-bit key, input 5
alphanumerics (or a 10-digit string for the hexadecimal format) for the 128-bit key,
input 13 alphanumerics (or a 26-digit string for the hexadecimal format).
Set a key. Input either 8 to 63 alphanumerics or a 64 digit string in the
hexadecimal format.
Select the EAP setup in the RADIUS server. Types of EAP that can be selected are
as follows.
PEAP (MS-CHAPv2), PEAP (GTC), EAP-TTLS (MD5), EAP-TTLS (MS-CHAPv2 ),
EAP-FAST (MS-CHAPv2), EAP-FAST (GTC)
Input a user name used for authentication (excluding spaces) (maximum 64
characters).
Input a password used for authentication (maximum 64 characters).
[SSID]
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[AUTHENTICATION]
[ENCRYPTION]
[CHANNEL]
[DNS1]/[DNS2]
Panasonic Projector
OFF
192.168.11.100
255.255.255.0
192.168.11.1
OPEN
NONE
11
NONE