[Off] - Panasonic PT-VW345NZ Operating Instructions Manual

[OFF]

[ON]
Note
f Audio cannot be output during standby when [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] or [NETWORK]
Æ
( page 77).
Setting audio input selection
Choose the audio input terminal for each input signal.
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select one item of [AUDIO IN SELECT].
[COMPUTER1]
[COMPUTER2]
[VIDEO]
[S-VIDEO]
[HDMI]
[NETWORK/USB]
4) Press qw to switch the item.
f The sub items will switch each time you press the button.
[COMPUTER1]
[COMPUTER2]
[VIDEO]
[S-VIDEO]
[HDMI]
[NETWORK/USB]
Note
f When [MIC] is set to [ON], [AUDIO IN 2] cannot be selected.
f Even if [AUDIO IN 2] is selected, it will change to [AUDIO IN 1] automatically when [MIC] is set to [ON].
Using MIC function
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [MIC].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
5) Press as to select [MIC GAIN].
6) Press qw to adjust the level.
Operation
Press the w button.
Press the q button.
Note
f When [OFF] is selected in MIC function, the MIC GAIN function is not available.
f If the MIC function is set to [ON] when connecting audio signals to the <AUDIO IN 2 (MIC IN)> terminal, loud sound may be
output suddenly depending on the setting value of [MIC GAIN].
f When [MIC] is set to [ON], no signal is input, AV MUTE function is on, FREEZE function is on or the POWER
MANAGEMENT function is working, the audio of MIC will be output.
Chapter 4 Settings - [PROJECTOR SETUP] menu
Disables audio output in the standby mode.
Enables audio output in the standby mode when [STANDBY MODE] is set to [NORMAL]. At this
time, press the <VOL - / VOL +> buttons on the remote control or qw buttons on the control panel
to adjust the volume.
Set the audio output when [COMPUTER1] input is selected.
Set the audio output when [COMPUTER2] input is selected.
Set the audio output when [VIDEO] input is selected.
Set the audio output when [S-VIDEO] input is selected.
Set the audio output when [HDMI] input is selected.
Set the audio output when [NETWORK/USB] input is selected.
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
Select one item among [HDMI AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
Select one item among [NETWORK/USB AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
<AUDIO IN 2> terminal switch to MIC input.
MIC is disabled.
Adjustment
Turns up the MIC mixing gain.
Turns down the MIC mixing gain.
Range
0 ~ 63
ENGLISH - 79