Powering On The Projector; Making Adjustments And Selections - Panasonic PT-VW345NZ Operating Instructions Manual

Powering On the Projector

Before switching on the projector, make sure all the other devices are correctly connected (
lens cap.
1)
1) Connect the power cord to the projector body.
2) Connect the power plug to an outlet.
f The power indicator <ON(G)/STANDBY(R)> lights or blinks, and the projector will enter the standby mode.
3) Press the <v/b> button on the control panel or the <b> button on the remote control.
f The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen.
Attention
f Using the projector while the lens cap is attached may cause the device to heat up and result in a fire.
Note
f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it may take approx. 10
seconds longer before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.

Making adjustments and selections

It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
1) Adjust the focus of the image roughly. (
2) Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (
f Refer to "Navigating through the menu" (
3) Press the <INPUT SELECT> button on the control panel or the input selection (<COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO/S-VIDEO>) buttons to select the input signal.
f <MEMORY VIEWER>, <Miracast> and <Panasonic APP> buttons on the remote control can also be used to switch the
input signal.
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (
5) If the input signal is an analog RGB signal, press the <AUTO SETUP/CANCEL> button.
6) Press the <EASY SETTING/CANCEL> button on the control panel.
f For details, refer to "Adjusting the projected image via EASY SETTING function". (
Note
f When the projector is switched on for the first time after purchase as well as when the [PROJECTOR SETUP] menu →
[INITIALIZE ALL] is executed, the initial setting screen is displayed after projection starts. Refer to "Start-up display" for
Æ
details. ( page 24)
42 - ENGLISH
Chapter 3 Basic Operations - Powering on/off
2)
Æ
Æ
page 31)
Æ
page 54) for the operation of the menu screen.
3)
5)
3)
6)
page 44)
Æ
pages 35-38) and remove the
3)
3)
Æ
page 34)
Æ
page 45)